how_to_crack_wep_with_no_clients
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
how_to_crack_wep_with_no_clients [2009/09/26 14:34] – Fixed typos darkaudax | how_to_crack_wep_with_no_clients [2010/11/21 09:19] – typos sleek | ||
---|---|---|---|
Line 103: | Line 103: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. (Note: If you are using a driver other than madwifi, then the Access Point field will be either invisible or show something other than your card's MAC address. This is normal.) | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. (Note: If you are using a driver other than madwifi, then the Access Point field will be either invisible or show something other than your card's MAC address. This is normal.) | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Troubleshooting Tips === | === Troubleshooting Tips === | ||
Line 234: | Line 233: | ||
When a packet from the access point arrives, enter " | When a packet from the access point arrives, enter " | ||
- | When successful, the system | + | When successful, the system |
| | ||
Line 451: | Line 450: | ||
Use this packet ? y | Use this packet ? y | ||
- | Enter " | + | Enter " |
| |
how_to_crack_wep_with_no_clients.txt · Last modified: 2018/03/11 20:15 by mister_x